Error Description:
Requirements not met for enabling Fast-Start Failover

Error Cause:
The attempt to enable Fast-Start Failover could not be completed because one or more requirements have not been met:

- The Data Guard configuration must be in MaxAvailability protection mode.

- The LogXptMode property for both the primary database and the Fast-Start Failover target standby database must be SYNC.

- The primary database and the Fast-Start Failover target standby database must both have flashback enabled.

- No valid target standby database was specified in the primary database"s FastStartFailoverTarget property prior to the attempt to enable Fast-Start Failover, and more than one standby database exists in the Data Guard configuration.

Action:
Retry the attempted command after correcting the issue:

- Set the Data Guard configuration to MaxAvailability protection mode.

- Ensure that the LogXptMode property for both the primary database and the Fast-Start Failover target standby database are SYNC.

- Ensure that both the primary database and the Fast-Start Failover target standby database have flashback enabled.

- Set the primary database's FastStartFailoverTarget property to the db_unique_name value of the desired target standby database add the desired target standby database's FastStartFailoverTarget property to the db_unique_name value of the primary database.

There haven't been any comments added for this error yet. You may add one if you like.  Add a comment

Name: Email: URL: Chars left:  1000  (1000 max) (No HTML, but newlines will be preserved)